OptiTip® Extender Trunks
Part Number: i2570-TIP-XX-X-X-X
The OptiTip® Extender Trunks provide the additional distance for the backbone.
The EDGE™ MTP® Extender Trunks provide the additional distance for the backbone of the EDGE Solution. With a non-pinned MTP on one end of the cable, a pinned MTP on the other, and a TIA-568 Type-A polarity,
These OptiTip® Extender Trunks are designed to interface with an EDGE or Plug & Play™ module and an MTP trunk. All trunks are shipped with strain-relief clips that allow for the tool-less installation in both EDGE and Plug & Play housings. Most often these extender trunks will be used in a Zone Distribution Area (ZDA).
The OptiTip® assembly is designed for use in outside plant fiber access networks with FlexNAP and OptiSheath® MDU and Fiber Distribution terminals. This innovative cable assembly solution provides enhanced design flexibility, increased deployment speed, and reduced installation cost.
The OptiTip® connector is the key enabler for quick connection of up to 12 fibers at a time. The connector is based on the field-proven MTP® connector technology encapsulated in a hardened package suitable for use in any environment. A male (pinned) version and a female (non pinned) version are easily joined to make a watertight terminal or in-line connection. Factory installation and testing ensure reliable, low optical loss on all fibers.
Quick Turn around, shorter lead time delivery for hard-to-get products.
Performance Specifications |
OptiTip® MT Connectors |
Operation | -40 °C to 70 °C (-40° to +158°F) |
Length | 3.47-in female, tip to end of the boot (4.07-in with dust cap installed) 3.29-in male, tip to end of the boot (4.23-in with dust cap installed) 3.29-in male, tip to end of the boot (4.23-in with dust cap installed) |
Maximum Outer Diameter | 0.7 in minimum recommended duct size is 1.25-in |
Mateability | Pinned alignment, male-to-female connector, or female connector to male adapter |
Qualification | EIA/TIA 568-B.3,GR-3152, IP 69K and IP 68 |
Reflectance | Single-mode OS2: ≤ -65 dB |
Tensile Strength | 100 lb when factory installed on SST-Drop™ or FREEDM® Flat-Drop Cable |
Insertion Loss, Maximum | 0.65 dB maximum per fiber |
Insertion Loss | 0.35 dB typical |